PDF p. 501 · 13-27
NOTE: The 3rd/4th and 5th synchro hubs and the ball bearing are installed with a press.
OIL Prior to reassembling, clean all the parts in solvent, dry them and apply lubricant to any contact surfaces. The 3rd/4th and 5th synchro hubs, however, should be installed with a
press before lubricating them.

- 1. SYNCHRO RING
Inspection, (See page 13-41) - 2. SYNCHRO SPRING
- 3. 3RD/4TH SYNCHRO HUB Inspection, (See page 13-40)
- 4. 3RD/4TH SYNCHRO SLEEVE Inspection, (See page 13-40)
- 5. SYNCHRO SPRING
- 6. SYNCHRO RING
Inspection, (See page 13-41) - 7. 3RD GEAR
Inspection, (See page 13-28) and (See page 13-41) - 8. NEEDLE BEARING
Check for wear and operation - 9. MAINSHAFT
Inspection, (See page 13-30) - 10. NEEDLE BEARING
Check for wear and operation - 11. BALL BEARING
Check for wear and operation - 12. STOPPER RING
- 13. TAPER RING
- 14. NEEDLE BEARING
Check for wear and operation - 15. SPACER COLLAR
- 16. SYNCHRO RING
Inspection, (See page 13-41) - 17. SYNCHRO SPRING
- 18. 5TH SYNCHRO HUB
Inspection, (See page 13-40) - 19. 5TH SYNCHRO SLEEVE Inspection, (See page 13-40)
- 20. SYNCHRO SPRING
- 21. SYNCHRO RING
Inspection, (See page 13-41) - 22. 5TH GEAR
Inspection, (See page 13-29) and (See page 13-41) - 23. SPACER COLLAR
Inspection, (See page 13-28) and (See page 13-41) - 24. 4TH GEAR
Inspection, (See page 13-28) and (See page 13-41)