Workshop manual

Shift Fork Assembly

Clearance Inspection

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 500 (manual page 13-26)

PDF p. 500 · 13-26

NOTE: The synchro sleeve and synchro hub should be replaced as a set.

  1. 1.

    Measure the clearance between each shift fork and its matching synchro sleeve.

    Standard:0.35 - 0.65 mm (0.014 - 0.026 in)
    Service limit:1.00 mm (0.039 in)
Illustration: SYNCHRO SLEEVE; SHIFT FORK
  1. 1. SYNCHRO SLEEVE
  2. 2. SHIFT FORK
  1. 2.
    If the clearance exceeds the service limit, measure the thickness of the shift fork fingers.

Standard:

3rd/4thshift fork 7.4 - 7.6 mm

(0.291 - 0.299 in)

1st/2nd shift fork6.2 - 6.4 mm
5th shift fork(0.244 - 0.252 in)
Illustration: SHIFT FORK
  1. 1. SHIFT FORK
  • If the thickness of the shift fork finger is less than the standard, replace the shift fork with a new one.
  • If the thickness of the shift fork finger is within the standard, replace the synchro sleeve with a new one.
  1. 3.

    Measure the clearance between the shift fork and the shift arm A.

    Standard:0.2 - 0.5 mm (0.008 - 0.019 in)
    Service limit:0.6 mm (0.024 in)
Illustration: 5TH/REVERSE SHIFT PIECE; 3RD/4TH SHIFT FORK; 1ST/2ND SHIFT FORK; SHIFT ARM A
  1. 1. 5TH/REVERSE SHIFT PIECE
  2. 2. 3RD/4TH SHIFT FORK
  3. 3. 1ST/2ND SHIFT FORK
  4. 4. SHIFT ARM A
  1. 4.

    If the clearance exceeds the service limit, measure the width of the shift arm A.

    Standard: 12.9 - 13.0 mm (0.508 - 0.512 in)

Illustration: SHIFT ARM A
  1. 1. SHIFT ARM A
  • If the width of the shift arm A is less than the standard, replace the shift arm A with a new one.
  • If the width of the shift arm A is within the standard, replace the shift fork or shift piece with a new one.