Workshop manual

Back-up Light Switch

Test Replacement

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 478 (manual page 13-5)

PDF p. 478 · 13-5

  1. 1.
    Disconnect the back-up light switch 2P connector.
Illustration · Back-up Light Switch · Test Replacement

1 WASHER, Replace

  1. 2.
    BACK-UP LIGHT SWITCH, 25 Nm (2.5 kgf/m, 18 lbf/ft)
  2. 2.
    Check the continuity between the terminals. There should be continuity when the shift lever is shifted into reverse.
  3. 3.
    If necessary, replace the switch.

Transfer Assembly

Inspection

  1. 1.
    Raise the front of the vehicle and support it with safety stands (see section 1).
  2. 2.
    Set the parking brake and block both rear wheels securely.
  3. 3.
    Shift to neutral position.
  4. 4.
    Make a reference mark across the propeller shaft and the transfer assembly flanges.
  5. 5.
    Separate the propeller shaft from the transfer assembly.
Illustration: REFERENCE MARKS; 8 x 1.25 mm, 32 Nm (3.3 kgf/m, 24 lbf/ft); PROPELLER SHAFT
  1. 1. REFERENCE MARKS
  2. 2. 8 x 1.25 mm, 32 Nm (3.3 kgf/m, 24 lbf/ft)
  3. 3. PROPELLER SHAFT