Workshop manual

Clutch Disc Pressure Plate

Installation

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 471 (manual page 12-13)

PDF p. 471 · 12-13

  1. 1.

    Apply grease to inner dia. Spline thinly and uniformly, mate and slide mainshaft and remove extra overflow grease.

    NOTE: Use only HONDA Genuine Urea Grease UM264 (P/N 41211-PY5-305).

  2. 2.
    Install the ring gear holder.
  3. 3.
    Install the clutch disc using the special tools as shown.
Illustration: CLUTCH ALIGNMENT TOOL SET, 07PAF-0020000; GREASE (P/N 41211-PY5-305); CLUTCH DISC; RING GEAR HOLDER, 07LAB-PV00100 or 07924-PD20003
  1. 1. CLUTCH ALIGNMENT TOOL SET, 07PAF-0020000
  2. 2. GREASE (P/N 41211-PY5-305)
  3. 3. CLUTCH DISC
  4. 4. RING GEAR HOLDER, 07LAB-PV00100 or 07924-PD20003
  1. 4.
    Install the pressure plate and the mounting bolts finger-tight.
Illustration: PRESSURE PLATE
  1. 1. PRESSURE PLATE
  1. 5.

    Torque the mounting bolts in a crisscross pattern as shown. Tighten the bolts in several steps to prevent warping the diaphragm spring.

    8 x 1.28 mm, 25 Nm (2.6 kgf/m, 19 lbf/ft)

Illustration: 8 x 1.25 mm, 25 Nm (2.6 kgf/m, 19 lbf/ft)
  1. 1. 8 x 1.25 mm, 25 Nm (2.6 kgf/m, 19 lbf/ft)
  1. 6.
    Remove the special tools.
  2. 7.
    Check the diaphragm spring fingers for height (See page 12-10).