PDF p. 466 · 12-9

: HONDA Genuine Urea Grease UM264
(P/N41211-PY5-305).

: Brake Assembly Lube or equivalent rubber
grease.
- 1.Disconnect the clutch pipe from the slave cylinder.

- 1. CLUTCH PIPE
- 2. SLAVE CYLINDER
- 2.Remove the slave cylinder from the clutch housing.
- 3.
Install the slave cylinder in the reverse order of removal.
NOTE: Make sure the boot is installed on the slave cylinder.

.
- 1.CLUTCH PIPE, 15 Nm (1.5 kgf/m, 11 lbf/ft)
- 2.SLAVE CYLINDER
- 3.8 x 1.25 mm, 22 Nm (2.2 kgf/m, 16 lbf/ft)
- 4.GREASE (Brake Assembly Lube)
- 5.GREASE (P/N 41211-PY5-305)
- 4.Bleed the clutch hydraulic system.
- Attach a hose to the bleeder screw, and suspend the hose in a container of brake fluid.
Make sure there is an adequate supply of fluid at the clutch master cylinder, then slowly
pump the clutch pedal until no more bubbles appear at the bleeder hose.
- Refill the clutch master cylinder with fluid when done.
- Use only genuine Honda Super Duty DOT 3 brake fluid or an equivalent DOT 3 or DOT 4 brake fluid.
- Confirm clutch operation and check for leaking fluid.

- 1. BLEEDER SCREW, 7.8 Nm (0.8 kgf/m, 5.8 lbf/ft)