Workshop manual

Oil Pump

Overhaul

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 305 (manual page 8-9)

PDF p. 305 · 8-9

NOTE:

  • Use new O-rings when reassembling.
  • Apply oil to O-rings before installation.
  • Use liquid gasket, Part No. 08C70-K0234M, 08C70-K0334M or 08C70 -X0331S
  • The rotors must be installed to the same direction.
  • After reassembly, check that the rotors move without binding.
Illustration: PUMP HOUSING Inspection, (See Page 8-10) Apply liquid gasket to mating surface of the cylinder block when installing.; DOWEL PIN; INNER ROTOR Inspection, (See Page 8-10); OUTER ROTOR Inspection, (See Page 8-10); 6 x 1.0 mm, 7 Nm (0.7 kgf/m, 5 lbf/ft); PUMP COVER; O-RING. Replace.; DOWEL PIN; RELIEF VALVE. Valve must slide freely in housing bore. Replace if scored.; WASHER; SEALING BOLT, 39 Nm (40 kgf/m, 29 lbf/ft); SPRING; 6 x 1.0 mm, 11 Nm (1.1 kgf/m, 8.0 lbf/ft); OIL SEAL Inspection, (See Page 8-10). Replace.; 6 x 1.0 mm, 11 Nm (1.1 kgf/m, 8.0 lbf/ft)
  1. 1. PUMP HOUSING
    Inspection, (See Page 8-10)
    Apply liquid gasket to mating surface of the cylinder block when installing.
  2. 2. DOWEL PIN
  3. 3. INNER ROTOR
    Inspection, (See Page 8-10)
  4. 4. OUTER ROTOR
    Inspection, (See Page 8-10)
  5. 5. 6 x 1.0 mm, 7 Nm (0.7 kgf/m, 5 lbf/ft)
  6. 6. PUMP COVER
  7. 7. O-RING. Replace.
  8. 8. DOWEL PIN
  9. 9. RELIEF VALVE. Valve must slide freely in housing bore. Replace if scored.
  10. 10. WASHER
  11. 11. SEALING BOLT, 39 Nm (40 kgf/m, 29 lbf/ft)
  12. 12. SPRING
  13. 13. 6 x 1.0 mm, 11 Nm (1.1 kgf/m, 8.0 lbf/ft)
  14. 14. OIL SEAL
    Inspection, (See Page 8-10). Replace.
  15. 15. 6 x 1.0 mm, 11 Nm (1.1 kgf/m, 8.0 lbf/ft)