PDF p. 304 · 8-8
- 1.Remove the YEL/RED wire from the engine oil pressure switch.
- 2.Check for continuity between the positive terminal and the engine (ground).
- There should be continuity with the engine stopped.
- There should be no continuity with the engine running.

- 1. POSITIVE TERMINAL
- 2. YEL/RED WIRE
- 3. ENGINE OIL PRESSURE SWITCH
- 3.If the switch fails to operate, check the engine oil level. If the engine oil level is OK, check the engine oil pressure.
Oil Pressure
Testing
If the oil pressure warning light stays on with the engine running, check the engine oil level. If the oil level is correct:
- 1.Connect a tachometer.
- 2.Remove the engine oil pressure switch and install an oil pressure gauge.

- 1. ENGINE OIL PRESSURE MOUNTING HOLE
- 2. OIL PRESSURE GAUGE, 07506-3000000
- 3. OIL PRESSURE GAUGE ATTACHMENT, 07406-0030000
- 3.Start the engine. Shut it off immediately if the gauge registers no oil pressure. Repair the problem before continuing.
- 4.
Allow the engine to reach operating temperature (fan comes on at least twice). The pressure should be:
Engine Oil Temperature: 80°C (176°F)
Engine oil Pressure:
At Idle: 70 kPa (0.7 kgf/cm2, 10
psi) minimum.
At 3,000 rpm (min-1) 340 kPa (3.5 kgf/cm2, 50 psi) minimum.
- If oil pressure is NOT within specifications, inspect the oil pump, (See Page 8-10).