PDF p. 293 · 7-23
- 6.
Check rod bearing clearance with plastigage (See page 7-10), then torque the cap nuts.
31 Nm (3.2 kgf/m, 23 lbf/ft)
Apply engine oil to the bolt threads.
NOTE: Reference numbers on connecting rods are for big-end bore tolerance and do not indicate the position of the piston in the engine.
- 7.Install the thrust washers on the No. 4 journal. Oil the thrust washer surfaces.

- 1. Line up the mark when installing connecting rod cap.
- 8.Install the main bearing caps.
- 9.
Check clearance with plastigage (See page 7-8), then tighten the bearing cap bolts in two steps. 1st step: 25 Nm (2.5 kgf/m, 18 lbf/ft)
2nd step: 51 Nm (5.2 kgf/m, 38 lbf/ft)
NOTE: Coat the thrust washer surfaces and bolt threads with oil.
MAIN BEARING CAP BOLTS TIGHTENING SEQUENCE

NOTE: Whenever any crankshaft or connecting rod bearing is replaced, it is necessary after reassembly to run the engine at idling speed until it reaches normal operating temperature, then continue to run it for approximately 15 minutes.
PDF p. 294 · 7-24
NOTE:
- Use liquid gasket, part No. 08C70-K0234M, 08C70-K0334M or 08C70-X0331S.
- Check that the mating surfaces are clean and dry before applying liquid gasket.
- Apply liquid gasket evenly, being careful to cover all the mating surface.
- To prevent leakage of oil, apply liquid gasket to the inner threads of the bolt holes.
- Do not install the parts if five minutes or more have elapsed since applying the liquid gasket. Instead, reapply liquid gasket after removing the old residue.
- After assembly, wait at least 30 minutes before filling the engine with oil.
10 Apply liquid gasket to the block mating surface of the
right side cover, then install it on the cylinder block.

- 1. Apply liquid gasket along the broken line.
- 2. RIGHT SIDE COVER
- 3. RIGHT SIDE COVER
- 4. 6 x 1.0 mm, 11 Nm (1.1 kgf/m, 8.0 lbf/ft)
- 5. DOWEL PIN
- 11.Apply liquid gasket to the oil pump mating surface of the block, then install the oil pump on the cylinder block.
Apply grease to the lips of the oil seals.
Then, install the oil pump while aligning the inner rotor, with the crankshaft. When the pump is in place, clean any excess grease off the crankshaft, then check that the oil seal are not distorted.

- 1. Apply liquid gasket along the broken line.
- 2. OIL PUMP HOUSING
- 3. 3 x 1.0 mm, 11 Nm (1.1 kgf/m, 8.0 lbf/ft)
- 4. OIL SCREEN
- 5. DOWEL PIN
- 6. O-RING. Replace.
- 7. OIL PUMP
- 8. 6 x 1.0 mm, 11 Nm (1.1 kgf/m, 8.0 lbf/ft)
- 9. DOWEL PIN
10 GASKET. Replace.
- 11.6 x 1.0 mm, 11 Nm (1.1 kgf/m, 8.0 lbf/ft)