Workshop manual

Valves, Valve Springs and Valve Seats

Installation

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 266 (manual page 6-27)

PDF p. 266 · 6-27

  1. 1.

    Insert the valves into the valve guides coat the valve stems with engine oil before inserting the valves.

    NOTE: Check the valves move up and down smoothly.

  2. 2.
    Install the spring seats on the cylinder head.
  3. 3.

    Install the valve seals using the special tool.

    NOTE: Exhaust and intake valve seal are not interchangeable.

Illustration: INTAKE VALVE SEAL; WHITE SPRING; EXHAUST VALVE SEAL; BLACK SPRING; STEM SEAL DRIVER, 07PAD-0010000. NOTE: Use 5.5 mm side.; VALVE SEAL. Replace.
  1. 1. INTAKE VALVE SEAL
  2. 2. WHITE SPRING
  3. 3. EXHAUST VALVE SEAL
  4. 4. BLACK SPRING
  5. 5. STEM SEAL DRIVER, 07PAD-0010000. NOTE: Use 5.5 mm side.
  6. 6. VALVE SEAL. Replace.
  1. 4.

    Install the valve spring and valve retainer, then install the valve spring compressor. Compress the spring, and install the valve keepers.

    NOTE: Place the end of valve spring with closely wound coils toward the cylinder head.

Illustration: VALVE SPRING COMPRESSOR, 07757-0010000
  1. 1. VALVE SPRING COMPRESSOR, 07757-0010000
  1. 5.

    Lightly tap the end of each valve stem two or three times with a plastic mallet to ensure proper seating of valve and valve keepers.

    NOTE: Tap the valve stem only along its so you do not bend the stem.

Illustration: PLASTIC MALLET; VALVE STEMS
  1. 1. PLASTIC MALLET
  2. 2. VALVE STEMS