Workshop manual

Dash Lights Brightness Controller (KQ model)

Control Unit Input Test (4D)

Supplement 2000 (5-door model) · source: HRV_Workshop_Manual.pdf, PDF page 2022 (manual page 23-D-7)

PDF p. 2022 · 23-D-7

  1. 1.
    Disconnect the 6P connector from the control unit.
  2. 2.
    Inspect the connector terminals to be sure they are all making good contact.
    • If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
    • If the terminals look OK, make the following input tests at the connector.
      • If any test indicates a problem, find and correct the cause, then recheck the system.
      • If all the input tests prove OK, the control unit must be faulty, replace it.
Illustration: DASH LIGHTS BRIGHTNESS CONTROL UNIT; 6P CONNECTOR; Wire side of female terminals
  1. 1. DASH LIGHTS BRIGHTNESS CONTROL UNIT
  2. 2. 6P CONNECTOR
  3. 3. Wire side of female terminals
CavityWireTest conditionTest: Desired resultPossible cause if result is not
obtained
5RED/BLKCombination lightCheck for voltage to ground:♦Blown No. 46 (7.5 A) fuse in the
switch ONThere should be battery voltage.under-dash fuse/relay box
♦Faulty combination light switch
♦Faulty taillight relay
♦An open in the wire
1BLKUnder allCheck for continuity to ground:♦Poor ground (G401, G402)
conditionsThere should be continuity.♦An open in the wire
4REDCombination lightConnect to ground:♦An open in the wire
switch ONDash lights should come on full
bright.