Workshop manual

Starting System

Starter Replacement

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 192 (manual page 4-8)

PDF p. 192 · 4-8

  1. 1.
    Disconnect the battery negative cable.
  2. 2.
    Disconnect the starter cable form the B terminal on the solenoid, then disconnect the BLK/WHT wire from the S terminal.
Illustration: 10 x 1.25 mm, 44 Nm (4.5 kgf/m, 33 lbf/ft); 10 x 1.25 mm, 44 Nm (4.5 kgf/m, 33 lbf/ft); BLK/WHT WIRE; B TERMINAL MOUNTING NUT, 9 Nm (0.9 kgf/m, 7 lbf/ft); STARTER CABLE
  1. 1. 10 x 1.25 mm, 44 Nm (4.5 kgf/m, 33 lbf/ft)
  2. 2. 10 x 1.25 mm, 44 Nm (4.5 kgf/m, 33 lbf/ft)
  3. 3. BLK/WHT WIRE
  4. 4. B TERMINAL MOUNTING NUT, 9 Nm (0.9 kgf/m, 7 lbf/ft)
  5. 5. STARTER CABLE
  1. 3.
    Remove the two bolts holding the starter, then remove the starter.
  2. 4.
    Install in the reverse order of removal. When installing the starter cable, make sure that the crimped side of the ring terminal is facing out.
Illustration: Crimped side of ring terminal; NUT; TERMINAL
  1. 1. Crimped side of ring terminal
  2. 2. NUT
  3. 3. TERMINAL
  1. 5.
    Connect the battery positve cable and negative cable to the battery.