Workshop manual

Wipers/Washers

Rear Window Intermittent Wiper Control Unit Input Test (KG and KE models)

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 1247 (manual page 23-F-28)

PDF p. 1247 · 23-F-28

  1. 1.
    Remove the driver’s lower pocket (see section 20).
  2. 2.
    Disconnect the 8P connector from the control unit.
  3. 3.
    Inspect the connector and socket terminals to make sure they are all making good contact.
    • If the terminals are bent, loose or corroded, repair them as necessary and recheck the system.
    • If all the input tests are OK, the control unit must be faulty, replace it.
      • If a test indicates a problem, find and correct the cause, then recheck the system.
      • If all the input tests OK, the control unit must be faulty, replace it.
Illustration: Wire side of female terminals; YEL; LT GRN/BLK; LT GRN; REAR WINDOW INTERMITTENT WIPER CONTROL UNIT; 8P CONNECTOR; YEL/BLK; GRN/BLK; BLK
  1. 1. Wire side of female terminals
  2. 2. YEL
  3. 3. LT GRN/BLK
  4. 4. LT GRN
  5. 5. REAR WINDOW INTERMITTENT WIPER CONTROL UNIT
  6. 6. 8P CONNECTOR
  7. 7. YEL/BLK
  8. 8. GRN/BLK
  9. 9. BLK
CavityWireTest conditionTest: Desired resultPossible cause if result is not
obtained
4BLKUnder all conditionsCheck for continuity to ground:♦Poor ground (G401, G402)
There should be continuity♦An open in the wire
6YEL/BLKIgnition switch ON (II)Check for voltage to ground:♦Blown No 4 (10A) fuse in the
There should be battery voltageunder-dash fuse/relay box.
♦An open in the wire
1YELIgnition switch ON (II)Check for voltage to ground:♦Blown No 4 (10A) fuse in the
rear windowThere should be battery voltageunder-dash fuse/relay box.
wiper/washer switch♦Faulty rear window
ONwiper/washer relay
♦An open in the wire
2LTIgnition switch ON (II)Check for voltage to ground:♦Blown No 4 (10A) fuse in the
GRN/BLKwiper arm to parkThere should be battery voltageunder-dash fuse/relay box.
position♦Faulty rear window wiper motor
♦An open in the wire
3LT GRNIgnition switch ON (II)Connect to ground: The rear♦Blown No 4 (10A) fuse in the
window wiper motor should rununder-dash fuse/relay box.
♦Faulty rear window wiper motor
♦An open in the wire
5GRN/BLKIgnition switch ON (II)Check for voltage to ground:♦Blown No 4 (10A) fuse in the
rear windowThere should be battery voltageunder-dash fuse/relay box.
wiper/washer switch♦Faulty rear window
ONwiper/washer relay
♦An open in the wire