PDF p. 1211 · 23-E-17
- 1.Remove the driver’s lower pocket (see section 20).
- 2.Disconnect the 6P connector from the control unit.
- 3.Inspect the connector and socket terminals to make sure they are all making good contact.
- If the terminals are bent, loose, or corroded, repair them as necessary and recheck the system.
- If the terminals look OK, make the following input tests at the connector.
- If any test indicates a problem, find and correct the cause, then recheck the system.
- If all the input tests prove OK, the control unit must be faulty, replace it.

- 1. POWER DOOR LOCK CONTROL UNIT
- 2. WHT/RED
- 3. Wire side of female terminals
- 4. YEL/RED
- 5. WHT/GRN
- 6. BLU/WHT
- 7. BLU/RED
- 8. BLK
- 9. 6P CONNECTOR
Disconnect the 6P connector from the power door lock control unit
| Cavity | Wire | Test condition | Test: Desired result | Possible cause if result is | |
|---|---|---|---|---|---|
| not obtained | |||||
| 3 | BLK | Under all conditions | Check for continuity to ground: | ♦ | Poor ground (G401, G402) |
| There should be continuity | ♦ | An open in the wire | |||
| 2 | YEL/RED | Connect the No. 2 | Check door lock operation: | ♦ | Faulty actuator |
| terminal to the No. 6 | All doors should unlock | ♦ | An open in the wire | ||
| terminal and the No. 1 | ♦ | Blown No. 25 (15A) fuse in | |||
| terminal to the No. 3 | the under-dash fuse/relay box | ||||
| terminal momentarily | |||||
| 1 | WHT/RED | Connect the No. 1 | Check door lock operation: | ♦ | Faulty actuator |
| terminal to the No. 6 | All doors should unlock | ♦ | An open in the wire | ||
| terminal and the No. 2 | ♦ | Blown No. 25 (15A) fuse in | |||
| terminal to the No. 3 | the under-dash fuse/relay box | ||||
| terminal momentarily | |||||
Reconnect the 6P connector to the power door lock control unit
| Cavity | Wire | Test condition | Test: Desired result | Possible cause if result is | |
|---|---|---|---|---|---|
| not obtained | |||||
| 6 | WHT/GRN | Under all conditions | Check for voltage to ground: | ♦ | Blown No. 25 (15A) fuse in |
| There should be battery voltage | the under-dash fuse/relay box | ||||
| ♦ | An open in the wire | ||||
| 5 | BLU/WHT | Driver’s door lock knob | Check for voltage to ground: | ♦ | Faulty driver’s door lock |
| in LOCK | There should be battery voltage | knob switch | |||
| ♦ | An open in the wire | ||||
| ♦ | Poor ground (G401, G402) | ||||
| 4 | BLU/RED | Driver’s door lock knob | Check for voltage to ground: | ♦ | Faulty driver’s door lock |
| in UNLOCK | There should be battery voltage | knob switch | |||
| ♦ | An open in the wire | ||||
| ♦ | Poor ground (G401, G402) | ||||