Workshop manual

Power Windows

Troubleshooting

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 1202 (manual page 23-E-8)

PDF p. 1202 · 23-E-8

NOTE: The numbers in the table show the troubleshooting sequence.

Illustration · Power Windows · Troubleshooting

Resetting the power window unit

Resetting the power window control unit is required after performing the following procedure:

  • Shutdown of battery power.
  • Shutdown of the electric power caused by both No. 52 (20A) and No. 4 (7.5A) fuses.
  • Open circuit caused by disconnected 14P connector from the power window master switch.
  • Removal of the regulator, glass or glass run channel.
  1. 1.
    Make sure the glass is installed properly.
  2. 2.
    Turn the ignition switch OFF.
  3. 3.
    Remove the No. 52 (20A) fuse in the under-hood fuse/relay box.
  4. 4.
    Turn the ignition switch ON (II) and hold on for one seconds, then turn it OFF. Install the No. 52 (20A) fuse in the under-hood fuse/relay box five seconds later after turning the ignitions switch OFF>
  5. 5.
    Make sure the driver’s window does not work in AUTO with the ignition switch ON (II).
  6. 6.
    Turn the ignition switch ON (II) to crank the engine.
  7. 7.
    Move the driver’s window all the way down by using the driver’s switch of the master switch by manual down.
  8. 8.
    Move the driver’s window all the way up by using the driver’s switch of the master switch by manual down for more than one second.

* If the window does not work in AUTO, reset the power window master switch according to the above procedures again.