Workshop manual

Lighting System

Combination Light Switch Test/Replacement

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 1171 (manual page 23-D-5)

PDF p. 1171 · 23-D-5

  1. 1.
    Remove the steering column covers (see section 17).
  2. 2.
    Disconnect the 16P connector from the combination light switch.
  3. 3.
    Remove the two screws, then pull out the combination light switch.
  4. 4.
    Inspect the connector terminals to make sure they are all making good contact.
    • If the terminals are bent, loose or corroded, repair them as necessary and recheck the system.
    • If the terminals look OK, check for continuity between them in each switch position according to the table. If there is no continuity between any of them, check for continuity in the switch harness.
      • If there is continuity in the switch harness, replace the combination light switch.
      • If there is no continuity in the switch harness, repair the harness or replace the combination light switch.
Illustration: KG, KY and KE models; 16P CONNECTOR; COMBINATION LIGHT SWITCH; KN, KT, KQ and KU models
  1. 1. KG, KY and KE models
  2. 2. 16P CONNECTOR
  3. 3. COMBINATION LIGHT SWITCH
  4. 4. KN, KT, KQ and KU models
Illustration · Lighting System · Combination Light Switch Test/Replacement