Workshop manual

Power Door Locks

Driver’s Door Lock Knob Switch Test

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 1214

PDF p. 1214

  1. 1.
    Remove the driver’s door panel (see section 20).
  2. 2.
    Disconnect the 3P connector from the knob switch (without keyless entry system or actuator (with keyless entry system.
Illustration: 3P CONNECTOR
  1. 1. 3P CONNECTOR
  1. 3.
    Check for continuity between the terminals in each switch position according to the table.
Illustration · Power Door Locks · Driver’s Door Lock Knob Switch Test

23-E-20 Driver’s Door Lock Actuator Test

(With Keyless Entry System)

  1. 1.
    Remove the driver’s door panel (see section 20).
  2. 2.
    Disconnect the 2P connector from the actuator.
Illustration: 2P CONNECTOR
  1. 1. 2P CONNECTOR
  1. 3.
    Check actuator operation by connecting power and ground according to the table.
Illustration · (With Keyless Entry System)