Workshop manual

Temperature Control

Adjustment

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 1055 (manual page 21-20)

PDF p. 1055 · 21-20

Air Mix Control Cable

NOTE: LHD type is shown, RHD type is symmetrical.

  1. 1.
    From under the hood, open the clamp, then disconnect the heater valve cable from the heater arm.
Illustration: CLAMP; HEATER VALVE CABLE; HEATER VALVE ARM
  1. 1. CLAMP
  2. 2. HEATER VALVE CABLE
  3. 3. HEATER VALVE ARM
  1. 2.
    From under the dash, disconnect the air mix control cable housing from the clamp, and disconnect the air mix control cable from the air mix control linkage.
Illustration: AIR MIX CONTROL CABLE; CLAMP; AIR MIX CONTROL LINKAGE
  1. 1. AIR MIX CONTROL CABLE
  2. 2. CLAMP
  3. 3. AIR MIX CONTROL LINKAGE
  1. 3.
    Set the temperature control dial to MAX COOL.
  2. 4.
    Turn the air mix control linkage fully clockwise as shown above, and hold it. Attach the air mix control cable to the air mix control linkage, then snap the air mix cable housing into the clamp.
  3. 5.
    From under the hood, turn the heater valve arm to the fully closed position as shown above and hold it. Attach the heater valve cable to the heater valve arm, and gently pull on the heater valve cable housing to take up any slack, then install the heater valve cable housing into the clamp.

Heater Valve Cable

NOTE: LHD type is shown, RHD type is symmetrical.

  1. 1.
    From under the hood, open the clamp, then disconnect the heater valve cable from the heater valve arm.
Illustration: CLAMP; HEATER VALVE CABLE; HEATER VALVE ARM
  1. 1. CLAMP
  2. 2. HEATER VALVE CABLE
  3. 3. HEATER VALVE ARM
  1. 2.
    From under the dash, disconnect the heater valve cable housing from the clamp, and disconnect the heater valve cable from the air mix control linkage.
Illustration: HEATER VALVE CABLE; AIR MIX CONTROL LINKAGE; STOP; CLAMP
  1. 1. HEATER VALVE CABLE
  2. 2. AIR MIX CONTROL LINKAGE
  3. 3. STOP
  4. 4. CLAMP
  1. 3.
    Set the temperature control dial to MAX COOL.
  2. 4.
    Turn the air mix control linkage fully clockwise as shown above, and hold it. Attach the heater valve cable to the air mix control linkage. Hold the end of the heater valve cable housing against the stop, then snap the heater valve cable housing into the clamp.
  3. 5.
    From under the hood, turn the heater valve arm to the fully closed position as shown above, and hold it. Attach the heater valve cable to the heater valve arm, and gently pull on the heater valve cable housing to take up an slack, then install the heater valve cable housing into the clamp.