Workshop manual

Dashboard

Steering Hanger Beam Replacement

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 988 (manual page 20-52)

PDF p. 988 · 20-52

SRS components are located in this area. Review the SRS component locations, precautions and procedures in the SRS section (24) before performing repairs or service.

NOTE:

  • When prying with a flat-tip screwdriver, wrap it with protective tape and apply protective tape around the related parts, to prevent damage.
  • An assistant is helpful when removing and installing the steering hanger beam.
  • Take care not to scratch the dashboard, body and other related parts.
  • Wear gloves to protect your hands.
  • LHD is shown, RHD is symmetrical.
  1. 1.
    Remove the dashboard (See Page 20-51).
  2. 2.
    Remove the main wire harness, SRS wire harness and interior wire harness from the steering hanger beam.

: Clip, holder location

Illustration · Dashboard · Steering Hanger Beam Replacement
  1. 3.
    Remove the bolts, then remove the steering hanger beam : Bolt locations
  1. 1.
    INERTIA SWITCH
  2. 2.
    STEERING HANGER BEAM
  3. 3.

    GROUND BOLT, 6 x 1.0 mm

    9.8 Nm (1.0 kgf/m, 7.2 lbf/ft)

  4. 4.
    6 x 1.0 mm 9.8 Nm (1.0 kgf/m, 7.2 lbf/ft)
  5. 5.
    MAIN WIRE HARNESS
  6. 6.
    SRS WIRE HARNESS
  7. 7.
    INTERIOR WIRE HARNESS
Illustration: HOOK; HOLE
  1. 1. HOOK
  2. 2. HOLE
  1. 4.
    Install in the reverse order of removal and note these items:
    • Make sure the dashboard wire harness and steering hanger beam wire harness are not pinched.
    • Make sure the connectors are plugged in properly.