Workshop manual

Interior Trim

Carpet Replacement

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 982 (manual page 20-46)

PDF p. 982 · 20-46

SRS components are located in this area. Review the SRS component locations, precautions and procedures in the SRS section (24) before performing repairs or service.

NOTE:

  • Wear gloves to protect your hands.
  • Take care not to damage, wrinkle or twist the carpet.
  • Be careful not to damage the dashboard or other interior trim pieces.
  1. 1.
    Remove:
    • Front seat (both sides, (See Page 20-54).
    • Rear seat cushion (See Page 20-59).
    • Front and rear console
    • Kick panel (both sides, (See Page 20-41).
    • Side trim (both sides, (See Page 20-41).
    • Front seat belt lower anchor (both sides, (See Page 20-3).
  2. 2.
    Remove the footrest.
  3. 3.
    Cut areas (A), (B), (C), (D) and (E) in the carpet, then pull it back.
  4. 4.
    Remove the clips and release the retainers and fasteners, then remove the carpet.

: Bolt locations, 2 : Clip locations, 2

Illustration · Interior Trim · Carpet Replacement
  1. 5.
    Install in the reverse order of removal and note these items:
    • Take care not to damage, wrinkle or twist the carpet.
    • Reattach the cut areas (A), (B), (C), (D) and (E) in the carpet with a wire tie.
  1. 1.
    FOOTREST
  2. 2.
    FASTENERS
  3. 3.
    RETAINER
  4. 4.
    CARPET