Workshop manual

Openers

Fuel Lid Opener Cable Replacement

Supplement 2000 (5-door model) · source: HRV_Workshop_Manual.pdf, PDF page 1989 (manual page 20-40)

PDF p. 1989 · 20-40

5D:

NOTE:

  • Take care not to scratch the body and related parts.
  • Take care not to bend the cable.
  1. 1.
    Remove these items:
    • Rear seat cushion (See Page 20-34)
    • Rear seat-back, left side (See Page 20-34)
    • Rear side trim, both sides (See Page 20-28)
    • Centre pillar lower trim (See Page 20-28)
    • Trunk side trim panel, left side (See Page 20-29)
    • Carpet, as necessary
  2. 2.
    Disconnect the fuel lid opener cable from the fuel lid opener. : Clip, cable cushion locations
Illustration: FUEL LID LATCH; FUEL LID OPENER CABLE (LHD); FUEL LID OPENER (LHD); WIRE HARNESS; OPENER CABLE; Route the opener cable under the wire harness.; FUEL LID OPENER (RHD); FUEL LID OPENER CABLE (RHD)
  1. 1. FUEL LID LATCH
  2. 2. FUEL LID OPENER CABLE (LHD)
  3. 3. FUEL LID OPENER (LHD)
  4. 4. WIRE HARNESS
  5. 5. OPENER CABLE
  6. 6. Route the opener cable under the wire harness.
  7. 7. FUEL LID OPENER (RHD)
  8. 8. FUEL LID OPENER CABLE (RHD)
  1. 3.
    Release the opener cable from the clips. Using a clip remover, detach the clips, and remove the cable cushion.
  2. 4.
    Remove the fuel lid latch, then remove the fuel lid opener cable from the vehicle.
  3. 5.
    Install in the reverse order of removal, and replace any damaged clips and cable cushion.