PDF p. 1021 · 20-85
NOTE: The steel core in the fenderwell trim cannot be restored to its original shape once it has been bent. Replace the fenderwell trim when the steel core is bent.
- 1.Remove the fenderwell trim by pulling it out.
- 2.Clean the body bonding surface with a sponge dampened in alcohol. After cleaning, keep oil, grease and water from getting on the clean surface.
- 3.Apply clear sealant into the channel of the fenderwell trim from end to end.
- 4.
Install the fenderwell trim
Sealant: Cemedines P/N 08712-0004, or equivalent

- 1. FENDERWELL TRIM
- 2. ADHESIVE
- 3. STEEL CORE
- 5.Scrape or wipe the excess sealant off with a towel. To remove sealant from a painted surface, wipe with a soft shop towel dampened in alcohol.
Protection Tape Replacement
Align the application tape with the front portion of rear fender edge, as shown, then press the protection tape into place. Remove the application tape.
NOTE:
- Before applying, clean the rear fender surface with a sponge dampened in alcohol.
- After cleaning, keep oil, grease and water from getting on the surface.
- When applying, make sure there are no wrinkles in the protection tape.
Attachment Point:

- 1. APPLICATION TAPE
- 2. Align.
- 3. PROTECTION TAPE
- 4. SIDE SILL PANEL