Workshop manual

Glossary

Body Repair Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF pages 1713, 1714, 1715 (manual pages 9-19 to 9-21)

PDF p. 1713 · 9-19

All PaintPainting of complete surface.
Air blowUsing compressed air to blow away dust and debris.
Block paintPainting a section only, such as a door.
Clear paint (clear coat)Clear paint without dye (pigment).
Double coatApplication of two paint coats.
Dry coatPaint which left the spray gun and dried partially before it reached the surface, thereby making the painted surface rough. Dry coating is
caused by too little paint being fed, too high an air pressure, too much distance between the painted surface and the gun, or moving the gun
too fast.
Dry filmPaint which has dried completely.
Dust coatPaint is applied thinner than a dry coat. Painted surface becomes rough.
ED paintingElectrostatic discharge painting.
EnamelFinishing paint pigmented with dye.
FeatheredgingSmoothing off the edges of painted surfaces.
Flash offEvaporation of the paint solvent. (Flash off time is the period between paint coat applications).
Ford cupA type of viscosity meter.
Gun strokeMovement of the paint gun.
HardenerHardening agent of two-liquid type paint or fillers.
Polycyanates and oxides are used for hardeners.
Heat-hardening acrylic resin paintComposed of acrylic resin and meramine resin, and hardened (forms a paint film) by baking.

PDF p. 1714 · 9-20

LacquerA type of paint that uses cellulose nitrate or other chemicals, and which dries by evaporation of its solvent agent.
Meramine resinUsed as component for aminoalkyd resin paint and heat-hardening acrylic resin paint.
Metallic-base paintPaint with aluminium powder for metallic tone.
Mist coatPainting for fade-in sections. A small amount of paint may be dissolved with slow-evaporating thinner, or thinner alone may be applied with
low pressure 150 - 200 kPa (1.5 - 2.0 kgf/cm2, 21.3 - 28.4 psi).
Mixing scaleColour mixing device.
OverlapBlending of spray patterns.
OverspraySpraying other than the area that needs painting.
PaddleA tool to mix paint
Paint dustDust of paint formed by spraying
Paper dispenserA paper posting device (masker) that combines tape and paper.
ScrapesTraces of scratches.
ScuffingParticles on the painted surface are lightly polished with fine emery paper (#600 or over).
Set (setting)Evaporation time of solvent in the paint, before drying the layer forcefully or by baking (May be considered the same as flash-off time).
Single coatApplication of paint in single layer.
Spot paintPainting of small section, such as for touch-up.
UndercoatUndercoat paint (such as primer and surfacer).

May be applied to lower section of car for noise prevention and rustproofing.

PDF p. 1715 · 9-21

Wet coatPaint is applied with an excess of solvent, thereby producing a painted surface that is smooth, glossy and has a wet look.
Wet filmPaint which has not dried completely.
Wet on wetApplication of the next coat of paint before the preceding layer has dried completely.
Wool bonnetWool grinder for compound polishing.