Workshop manual

Wheel Alignment

Service Information

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 857 (manual page 18-4)

PDF p. 857 · 18-4

NOTE: For proper inspection/adjustment of the wheel alignment, check and adjust the following before checking the alignment.

  • Check that the suspension is not modified.
  • Check the tyre size and pressure.
  • Check the runout of the wheels and tyres.
  • Check the suspension ball joints. (Hold the wheel with your hands, then move it up and down and right and left to check for wobbling.)
Illustration · Wheel Alignment · Service Information

Wheel alignment adjustment procedure

Each of the wheel alignment elements relates to the other. Therefore, the total adjustment of the front/rear wheel alignment is required whenever either one of the elements (camber caster, toe and/or turning angle) is adjusted.

Illustration · Wheel alignment adjustment procedure

Special Tool Information

Wheel alignment gauge attachment:

NOTE:

  • As the wheel alignment gauge attachment can be installed by the magnetic force of the camber/caster gauge, make sure the wheel hubs are clean and rust free before installing the wheel alignment gauge attachment.
  • When installing the special tool, align the special tool groove and mating surface groove of the camber/caster gauge, to make the most of the magnetic force of the camber/caster gauge.
  • For accurate readings, measure the wheel alignment the car must be level.
Illustration: WHEEL ALIGNMENT GAUGE ATTACHMENT, 07MGK-0010100
  1. 1. WHEEL ALIGNMENT GAUGE ATTACHMENT, 07MGK-0010100

Camber

Inspection

  1. 1.
    Remove the wheel cap.
  2. 2.
    Remove the hub cap from the rear wheel hub (see page 18-19).
  3. 3.
    Install the wheel alignment gauge attachment and the camber/caster gauge on the wheel hub.
  4. 4.
    Turn the front wheels to the straight ahead position.
  5. 5.

    Rear the camber on the gauge with the bubble at the centre of the gauge.

    Camber angle:

    Front: 0°00’ ± 1°

    Rear: -0°30’ ± 1°

  6. 6.
    If out of specification, check for bent or damage suspension components.
Illustration: WHEEL ALIGNMENT GAUGE ATTACHMENT, 07MGK-0010100; HUB CAP, Replace.; CAMBER/CASTER GAUGE EQUIVALENT, COMMERCIALLY AVAILABLE
  1. 1. WHEEL ALIGNMENT GAUGE ATTACHMENT, 07MGK-0010100
  2. 2. HUB CAP, Replace.
  3. 3. CAMBER/CASTER GAUGE EQUIVALENT, COMMERCIALLY AVAILABLE