Workshop manual

Steering Column

Inspection

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF pages 820, 821 (manual pages 17-25 to 17-26)

PDF p. 820 · 17-25

  • Check the steering column ball bearing and the steering joint bearings for play and proper movement. If there is noise or if there is excessive play, replace the steering column as an assembly.
  • Check the retaining collar for damage, if it is damaged, replace the steering column as an assembly.
  • Check the absorbing plates for distortion breakage. If there is distortion breakage, replace the steering column as an assembly
Illustration: COLUMN BALL BEARING; ABSORBING PLATES; RETAINING COLLAR; STEERING JOINT BEARINGS
  1. 1. COLUMN BALL BEARING
  2. 2. ABSORBING PLATES
  3. 3. RETAINING COLLAR
  4. 4. STEERING JOINT BEARINGS

PDF p. 821 · 17-26

  1. 1.

    Move the tilt lever from the loose position to the lock position 3 to 5 times; then measure the tilt lever preload 10 mm (0.4 in) from the end of the tilt lever.

    Preload: 70-90 N (7-9 kgf, 15-20 lbf)

Illustration: SPRING SCALE, (Commercially available); TILT LOCK BOLT Tighten the lock bolt with the tilt lever raised.; 6 mm LOCK BOLT, 9.8 Nm (1.0 kgf/m, 7.2 lbf/ft); STOP; 10 mm (0.4 in)
  1. 1. SPRING SCALE, (Commercially available)
  2. 2. TILT LOCK BOLT
    Tighten the lock bolt with the tilt lever raised.
  3. 3. 6 mm LOCK BOLT, 9.8 Nm (1.0 kgf/m, 7.2 lbf/ft)
  4. 4. STOP
  5. 5. 10 mm (0.4 in)
  1. 2.
    If the measurement is out of the specification, adjust the preload using the following procedures:
    • Loosen the tilt lever, and set the steering column in the neutral position.
    • Remove the 6 mm lock bolt, and remove the stop. Be careful not to loosen the tilt lever when installing the stop or tightening the 6 mm lock bolt.
    • Adjust the preload by turning he tilt lock bolt left or right.
    • Pull up the tilt lever to the uppermost position, and install the stop. Check the preload again. If the measurement is still out of specification, repeat the above procedures to adjust.

Steering Lock Replacement

  1. 1.
    Remove the steering column (See page 17-23).
  2. 2.
    Centre punch each of the two shear bolts, and drill their heads off with a 5 mm (3/16 in.) drill bit. Be careful not to damage the switch body when removing the shear bolts.
Illustration · Steering Lock Replacement
  1. 3.
    Remove the shear bolts from the switch body.
  2. 4.
    Install the switch body without the key inserted.
  3. 5.
    Loosely tighten the new shear bolts.
  4. 6.
    Insert the ignition key, and check for proper operation of the steering wheel lock and that the ignition key turns freely.
  5. 7.
    Tighten the shear bolts until the hex heads twist off.
Illustration: SHEAR BOLT; TWIST-OFF PORTION
  1. 1. SHEAR BOLT
  2. 2. TWIST-OFF PORTION