PDF p. 817 · 17-22
- 1.Before installing the steering wheel, make sure the front wheels are aligned straight ahead, then centre the cable reel. Do this by first rotating the cable reel clockwise until it stops. Then rotate it counterclockwise approximately two and half turns. The arrow mark on the cable reel label point should point straight up.

- 1. CABLE REEL
- 2. ARROW MARK
- 2.Position the two tabs of the turn signal cancelling sleeve as shown, and install the steering wheel on to the steering column shaft, making sure the steering wheel shaft engages the pins of the cable reel and tabs of the cancelling sleeve. Do not tap on the steering wheel or steering column shaft when installing the steering wheel.

- 1. CABLE REEL
- 2. TURN SIGNAL CANCELLING SLEEVE
- 3. STEERING WHEEL SHAFT
- 4. TAB
- 5. PIN
- 3.
Install the steering wheel nut and tighten it to 49
Nm (5.0 kgf/m, 36 lbf/ft).
- 4.Connect the horn connector and mode select switch connector.
- 5.Install the driver’s airbag assembly, and confirm that the system is operating properly (see section 24).
- 6.Check the horn, mode select switch and turn signal cancelling for proper operation.