Workshop manual

Steering Wheel

Removal

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 815 (manual page 17-20)

PDF p. 815 · 17-20

SRS components are located in this area. Review the SRS component locations, precautions, and procedures in the SRS section (24) before performing repairs or service.

  1. 1.
    Align the front wheels straight ahead, then remove the driver’s airbag assembly from the steering wheel (see section 24).
  2. 2.
    Disconnect the horn connector and mode select switch connector if equipped.
Illustration: HORN CONNECTOR; MODE SELECT SWITCH CONNECTOR
  1. 1. HORN CONNECTOR
  2. 2. MODE SELECT SWITCH CONNECTOR
  1. 3.

    Loosen the steering wheel bolt, then install a steering wheel puller on the steering wheel and remove it.

    Note these items when removing the steering wheel:

    • Do not tap on the steering wheel or the steering column shaft when remove the steering wheel.
    • If you thread the puller bolts into the wheel hub more than five threads, the bolts will hit the cable reel and damage it. To prevent this, install a pair of jam nuts five threads up on each puller bolt.
Illustration: PULLER BOLTS; STEERING WHEEL BOLT; STEERING WHEEL PULLER; STEERING WHEEL
  1. 1. PULLER BOLTS
  2. 2. STEERING WHEEL BOLT
  3. 3. STEERING WHEEL PULLER
  4. 4. STEERING WHEEL