PDF p. 1944 · 14-13
| Number of D | ||||||
|---|---|---|---|---|---|---|
| When PCM | Indicator Light | Refer to | ||||
| senses | indicates | Page in | ||||
| abnormality, | the ’99 | |||||
| D | DTC on Honda | Symptom | Possible Cause | HR-V | ||
| indicator | PGM Tester | shop | ||||
| light: | manual | |||||
| DTC on OBD | (62S2H00) | |||||
| Scan Tool | ||||||
| 5 | ♦ | Transmission shifts | ♦ | Short in A/T gear position switch wire | (See | |
| same as D | ♦ | Faulty A/T gear position switch | page | |||
| Blinks | 5-1 | position in any | 14-40) | |||
| positions. | ||||||
| P1705 | ||||||
| 6 | ♦ | Transmission shifts | ♦ | Disconnected A/T gear position switch | (See | |
| Does not blink | same as D | connector | page | |||
| 6-1 | position in any | ♦ | Open in A/T gear position switch wire | 14-42) | ||
| positions. | ♦ | Faulty A/T gear position switch | ||||
| P1706 | ||||||
| Poor acceleration, | ♦ | Disconnected solenoid harness | (See | |||
| 30 | flares on starting off. | connector | page | |||
| ♦ | Short or open in shift control linear | 14-44) | ||||
| Blinks | 30-1 | solenoid wire | ||||
| ♦ | Faulty shift control linear solenoid | |||||
| P1870 | ♦ | Open in VB SOL line | ||||
| ♦ | Faulty PG line | |||||
| Poor acceleration, | ♦ | Disconnected solenoid harness | (See | |||
| 31 | flares on starting off. | connector | page | |||
| ♦ | Short or open in PH-PL control linear | 14-46) | ||||
| Blinks | 31-1 | solenoid wire | ||||
| ♦ | Faulty PH-PL linear solenoid | |||||
| P1873 | ♦ | Open in VB SOL line | ||||
| ♦ | Faulty PG line | |||||
| Poor acceleration, | ♦ | Disconnected solenoid harness | (See | |||
| 32 | flares on starting off. | connector | page | |||
| ♦ | Short or open in start clutch control linear | 14-48) | ||||
| Blinks | 32-1 | solenoid wire | ||||
| ♦ | Faulty start clutch control linear solenoid | |||||
| P1879 | ♦ | Open in VB SOL line | ||||
| ♦ | Faulty PG line | |||||
| 33 | No specific symptom | ♦ | Disconnected solenoid harness | (See | ||
| appears. | connector | page | ||||
| Blinks | 33-1 | ♦ | Short or open in inhibitor solenoid wire | 14-50) | ||
| ♦ | Faulty inhibitor solenoid | |||||
| P1882 | ♦ | Open in VB SOL line | ||||
| ♦ | Faulty PG line | |||||
PDF p. 1945 · 14-14
| Number of D | |||||
|---|---|---|---|---|---|
| When PCM | Indicator Light | Refer to | |||
| senses | indicates | Page in | |||
| abnormality, | the ’99 | ||||
| D | DTC on Honda | Symptom | Possible Cause | HR-V | |
| indicator | PGM Tester | shop | |||
| light: | manual | ||||
| DTC on OBD | (62S2H00) | ||||
| Scan Tool | |||||
| 34 | Poor acceleration, | ♦ | Disconnected drive pulley speed sensor | (See | |
| flares on starting off. | connector | page | |||
| Blinks | 34-1 | ♦ | Short or open in drive pulley speed | 14-52) | |
| sensor wire | |||||
| P1885 | ♦ | Faulty drive pulley speed sensor | |||
| 35 | Poor acceleration, | ♦ | Disconnected driven pulley speed sensor | (See | |
| flares on starting off. | connector | page | |||
| Blinks | 35-1 | ♦ | Short or open in driven pulley speed | 14-54) | |
| sensor wire | |||||
| P1886 | ♦ | Faulty driven pulley speed sensor | |||
| 36 | Poor acceleration, | ♦ | Disconnected secondary gear shaft | (See | |
| flares on starting off. | speed sensor connector | page | |||
| Blinks | 36-1 | ♦ | Short or open in secondary gear shaft | 14-56) | |
| speed sensor wire | |||||
| P1888 | ♦ | Faulty secondary gear shaft speed | |||
| sensor | |||||
| 42 | Poor acceleration, | ♦ | Faulty shift control system | (See | |
| flares on starting off. | page | ||||
| Blinks | 42-1 | 14-58) | |||
| P1890 | |||||
| 43 | Poor acceleration, | ♦ | Faulty start clutch control system | (See | |
| flares on starting off. | page | ||||
| Blinks | 43-1 | 14-59) | |||
| P1891 |
NOTE:
- If a customer described the symptom for code 6, 6-1, P1706, it will be necessary to recreate the symptom by test driving, then recheck the DTC.
- Sometimes the D indicator light and the Malfunction Indicator Lamp (MIL) may come on simultaneously. If so, repair the PGM-FI system according to the DTC, then reset the memory by removing the BACK UP fuse in the under-dash fuse/relay box for more than 10 seconds. Drive the vehicle for several minutes at a speed over 30 mph (50 km/h), then recheck the DTC.