PDF p. 590 · 14-36
When the PCM senses an abnormality in the input or output systems, the D indicator light in the gauge assembly will blink. What the Service Check Connector (located under the dash on the passenger side) is connected with the special tool as shown, the D indicator light will blink the Diagnostic Trouble Code (DTC) when the ignition switch is turned ON (II). When the D indicator light has been reported on, connect the Service Check Connector with the special tool.
Then turn ON (II) the ignition switch and observe the D indicator light.

- 1. GAUGE ASSEMBLY
- 2. DATA LINK CONNECTOR (3P)
- 3. SERVICE CHECK CONNECTOR (2P)
- 4. SCS SHORT CONNECTOR 07PAZ-0010100
- 5. INDICATOR LIGHT
Codes 1 through 9 are indicated by individual short blinks. Codes 10 and above are indicated by a series of long and short blinks. One long blink equals 10 short blinks. Add the long and short blinks together to determine the code. After determining the code, refer to the electrical system System-to Component Chart (See Page 14-38) and (See Page 14-39).

Some PGM-FI problems will also make the D indicator light come on. After repairing the PGM-FI system, disconnect the BACK-UP fuse (7.5 A) in the under-dash fuse/relay box for more than 10 seconds to reset the PCM memory, then recheck.
NOTE: Disconnecting the BACK-UP fuse also cancels the radio preset stations, clock setting and the feed back signal for the start clutch control. Make note of the radio presets before removing the fuse so you can reset them and to memorise the feedback signal for the start clutch control again follow the Memorising Feedback Signal procedures (See Page 14-71).
PDF p. 591 · 14-37
- 1.Remove the glove box (see section 20).
- 2.
Remove the PCM.
NOTE: RHD is shown: LHD is symmetrical.

- 1. 6 x 1.0 mm, 9.8 Nm (1.0 kgf/m, 7.2 lbf/ft)
- 2. PCM
- 3.Inspect the circuit on the PCM according to the troubleshooting flowchart with a digital multitester and a tapered tip probe as shown.

- 1. PCM
- 2. DIGITAL MULTITESTER Commercially available or 07411-0020000
- 3. TAPERED TIP PROBE
- PCM Reset Procedure
- 1.Turn the ignition switch off.
- 2.
Remove the BACK-UP fuse (7.5 A) from the under-dash fuse/relay box for 10 seconds to reset the PCM.
NOTE: Disconnecting the BACK-UP fuse also cancels the radio preset stations, clock setting and the feed back signal for the start clutch control. Make note of the radio presets before removing the fuse so you can reset them and to memorise the feedback signal for the start clutch control again follow the Memorising Feedback Signal procedures (See Page 14-71).

- 1. UNDERHOOD FUSE/RELAY BOX
- 2. BACK-UP FUSE (7.5 A)
Final Procedure
NOTE: This procedure must be done after any troubleshooting.
- 1.Remove the special tool from the Service Check Connector.
- 2.Reset the PCM
- 3.Set the radio preset stations and clock setting.
- 4.Follow the Start Clutch Control Memorising Feedback Signal procedures to store in the PCM (See Page 14-71).