Workshop manual

Transfer Assembly

Inspection

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 691 (manual page 14-134)

PDF p. 691 · 14-134

NOTE: To prevent damage to the transfer housing, always use soft jaws or equivalent materials between the transfer housing and the vice.

Transfer Gear (Hypoid gear) Backlash Measurement

  1. 1.
    Set a dial indicator on the companion flange as shown.
  2. 2.

    Measure the transfer gear backlash.

    STANDARD: 0.06 - 0.16 mm (0.02 - 0.06 in)

Illustration: DUAL INDICATOR; COMPANION FLANGE
  1. 1. DUAL INDICATOR
  2. 2. COMPANION FLANGE

Total Starting Torque Measurement

  1. 3.
    Rotate the companion flange several times to seat the tapered roller bearing.
  2. 4.

    Measure the starting torque (companion flange side) using a torque wrench as shown.

    STANDARD:

    2.68 - 3.47 Nm (27.3 - 35.4 kgf/cm, 23.7 - 30.7 lbf/in)

Illustration: COMPANION FLANGE; TRANSFER SHAFT; TORQUE WRENCH
  1. 1. COMPANION FLANGE
  2. 2. TRANSFER SHAFT
  3. 3. TORQUE WRENCH

Transfer Gear (Hypoid gear) Tooth Contract Inspection

  1. 5.
    Remove transfer cover B, then apply Prussian Blue to both sides of the transfer gear teeth lightly and evenly.
Illustration: TRANSFER DRIVE GEAR
  1. 1. TRANSFER DRIVE GEAR
  1. 6.
    Rotate the companion flange in both directions until the transfer gear rotates one full turn in both directions.
  2. 7.
    Check the transfer gear tooth contact pattern.
Illustration · Transfer Gear (Hypoid gear) Tooth Contract Inspection
  1. 8.
    If the measurements or the tooth contact pattern are not within the standard, disassembly the transfer assembly, replace worn or damaged parts and reassemble it.