Workshop manual

Differential

Backlash Inspection

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 679 (manual page 14-124)

PDF p. 679 · 14-124

  1. 1.
    Place the differential assembly on V-blocks and install both axles.
  2. 2.
    Set a dial indicator to the pinion gear.
  3. 3.

    Check the backlash of the pinion gears.

    STANDARD: 0.05 - 0.15 mm (0.002 - 0.006 in)

Illustration: PINION GEAR; DIAL INDICATOR; PINION GEAR
  1. 1. PINION GEAR
  2. 2. DIAL INDICATOR
  3. 3. PINION GEAR
  1. 4.
    If the backlash is out of standard, replace the differential carrier.

Bearing Replacement

NOTE: Check the bearings for wear and rough rotation, if the bearing is OK, removal is not necessary.

  1. 1.
    Remove the bearings using the bearing puller
Illustration: BEARING PULLER (Commercially available); BALL BEARING
  1. 1. BEARING PULLER (Commercially available)
  2. 2. BALL BEARING
  1. 2.
    Install the new bearings using the special tool and a press.
Illustration: DRIVER 40 mm, I.D. 07746-0030100; BALL BEARING
  1. 1. DRIVER 40 mm, I.D. 07746-0030100
  2. 2. BALL BEARING