PDF p. 475 · 13-2
This 4WD model does not have the feature that mechanically switches between 4WD and 2WD (front-wheel drive). Therefore, speedometer testing should be conducted using simplified free rollers under the rear wheels.
Precautions on using free rollers:
Inspecting and testing using a chassis
dynamometer is not feasible.
- Do not operate the accelerator pedal, brake pedal or steering wheel abruptly. It may cause the vehicle to roll and create a hazardous condition.
- The maximum testing speed should be 50 km/p (31 mph).
- The maximum continuous operating time should be three minutes.
- Make sure you tie the vehicle down securely with the side anchor wires and centre tie down wire. The free rollers are to be set under the rear wheels.
Testing Procedures
- 1.Set the free rollers according to the wheel base and tread of the vehicle.

- 1. FREE ROLLER
- 2. SPEEDOMETER TESTER
NOTE: Align the position marker notch to the positioning line.

- 2.Move the vehicle to position the front wheels on the speedometer testers and the rear wheels on the free rollers. Make sure to align the centre of the wheels to the centre of the speedometer testers and the free rollers.

- 3.Tie down the vehicle securely using the towing hook and the rear tie-down hook bracket to prevent the vehicle from rolling off or over the free rollers.
- 4.Start the engine, shift the transmission to 3rd gear (manual transmission) or to D position (CVT/Honda Multi Matic), accelerate the vehicle gradually and measure the vehicle speed.
- 5.After measurement, use the brake pedal to gradually decelerate and stop the vehicle.