PDF p. 327 · 10-15
- 1.Check the No. 6 (7.5 A) fuse in the driver’s under-dash fuse/relay box before testing.
- 2.Make sure the ignition switch is OFF, then disconnect the YEL/GRN wire from the coolant temperature gauge sending unit, and ground with a jumper wire.

- 1. GAUGE SENDING UNIT
- 2. YEL/GRN WIRE
- 3.
Turn the ignition switch ON (II).
Check that the pointer of the coolant temperature gauge starts moving towards the “H” mark. Turn the ignition switch OFF before the pointer reaches the “H” on the gauge dial. Failure to do so may damage the gauge.
If the pointer of the gauge does not move at all, check for an open in the YEL/GRN wire.
If the wires are OK, replace the coolant temperature gauge.
- If the coolant temperature gauge works, test the coolant temperature sending unit.
Sending Unit Testing
- 1.Disconnect the YEL/GRN wire from the coolant temperature gauge sending unit.

- 1. POSITIVE TERMINAL
- 2. SENDING UNIT
- 3. YEL/GRN WIRE
- 2.Using an ohmmeter, measure the change in resistance between the positive terminal and the engine (ground) with the engine cold and with the engine at operating temperature.
Temperature 56°C (133°F) 85 - 100°F
(185 - 212°C)
Resistance ohms 137 46 - 30
- 3.If the obtained readings are substantially different from the specifications above, replace the sending unit.