Workshop manual

Fan Control

Fan Motor Testing

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 326 (manual page 10-14)

PDF p. 326 · 10-14

  1. 1.
    Disconnect the 2P connectors from the radiator fan motor.
Illustration: RADIATOR FAN MOTOR; LOCK; Terminal side of male terminals
  1. 1. RADIATOR FAN MOTOR
  2. 2. LOCK
  3. 3. Terminal side of male terminals
  1. 2.
    Test the motor by connecting battery power to the B terminal, and ground the A terminal.
  2. 3.
    If the motor fails to run or does not run smoothly, replace it.

Radiator Fan Switch Testing

NOTE: Bleed air from the cooling system after installing the radiator fan switch, (See Page 10-5)

  1. 1.
    Remove the radiator fan switch from the thermostat cover, (See Page 10-8).
  2. 2.
    Suspend the radiator fan switch in a container of water as shown.
Illustration: THERMOMETER; RADIATOR FAN SWITCH; WATER
  1. 1. THERMOMETER
  2. 2. RADIATOR FAN SWITCH
  3. 3. WATER
  1. 3.
    Heat the water and check the temperature with a thermometer. Do not let the thermometer touch the bottom of hot container.
  2. 4.
    Measure the continuity between the A terminal and B terminal according to the table below.
Illustration · Radiator Fan Switch Testing