Workshop manual

Radiator

Engine Coolant Refilling and Bleeding

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF pages 317, 318 (manual pages 10-5 to 10-6)

PDF p. 317 · 10-5

  1. 1.
    Start the engine. Set the heater temperature control dial to maximum heat, then turn off the engine. make sure the engine and radiator are cool to the touch.
  2. 2.
    Remove the radiator cap.
  3. 3.
    Loosen the drain plug, and drain the coolant.
Illustration: DRAIN PLUG
  1. 1. DRAIN PLUG
  1. 4.
    Remove the drain bolt from the rear side of the cylinder block.
Illustration: WASHER. Replace; DRAIN BOLT, 83 Nm (8.5 kgf/m, 61 lbf/ft)
  1. 1. WASHER. Replace
  2. 2. DRAIN BOLT, 83 Nm (8.5 kgf/m, 61 lbf/ft)
  1. 5.
    Apply liquid gasket to the drain bolt threads, then reinstall the bolt with a new washer and tighten it securely.
  2. 6.
    Tighten the radiator drain plug securely.
  3. 7.
    Remove, drain and reinstall the reservoir. Fill the tank halfway to the MAX mark with water, then up to MAX mark with antifreeze.
Illustration: MAX MARK
  1. 1. MAX MARK
  1. 8.

    Mix the recommended antifreeze with an equal amount of water in a clean container.

    NOTE:

    • Use only genuine Honda antifreeze/coolant.
    • For best corrosion protection, the coolant concentration must be maintained year-round at 50% minimum. Coolant concentrations less then 50% may not provide sufficient protection against corrosion or freezing.
    • Coolant concentrations greater than 60% will impair cooling efficiency and are not recommended.
    • Do not use additional rust inhibitors or anti-rust products; they may not be compatible with the coolant.

Engine Cooling System Capacity [Including reservoir capacity: 0.4 l (0.42 US qt, 0.35 Imp qt)]

M/T: 2.8 l (3.0 US qt, 2.5 Imp qt)

CVT: 3.0 I (3.2 US qt, 2.6 Imp qt)

PDF p. 318 · 10-6

  1. 9.
    Pour coolant into the radiator up to the base of the filler neck.
Illustration · Radiator · Engine Coolant Refilling and Bleeding
  1. 10.
    Start the engine and let it run until it warms up (the radiator fan comes on at least twice).
  2. 11.
    Turn off the engine. Check the level in the radiator, add coolant if needed.
  3. 12.
    Put the radiator cap on tightly, then run the engine again and check for leaks.