Workshop manual

General Troubleshooting Information

How to Reset the ECM/PCM

Supplement 2000 (5-door model) · source: HRV_Workshop_Manual.pdf, PDF page 1818 (manual page 11-37)

PDF p. 1818 · 11-37

You can reset the ECM/PCM in either of two ways:

  • Use the scan tool or Honda PGM Tester to clear the ECM’s/PCM’s memory. See the scan tool or Honda PGM Tester user’s manuals for specific operating instructions.
  • Turn the ignition switch OFF, and remove the BACK UP (7.5 A) fuse from the under-dash fuse/relay box for 10 seconds.
Illustration: UNDER-DASH FUSE/RELAY BOX; BACK UP (7.5 A) FUSE
  1. 1. UNDER-DASH FUSE/RELAY BOX
  2. 2. BACK UP (7.5 A) FUSE

The illustration shows LHD type.

RHD is symmetrical.

How to End a Troubleshooting Session

This procedure must be done after any troubleshooting.

  1. 1.
    Do the ECM/PCM Reset Procedure.
  2. 2.
    Turn the ignition switch OFF.
  3. 3.

    Disconnect the scan tool or Honda PGM Tester from the data link connector (16P).

    NOTE: The ECM/PCM is part of the immobiliser system. If you replace the ECM/PCM, the ECM/PCM will have a different immobiliser code. In order for the engine to start, you must rewrite the immobiliser code with the Honda PGM Tester.

How to Substitute the ECM/PCM for Testing Purposes

Use this procedure if you need a known-good

ECM/PCM to test a vehicle. It allows you to swap a ECM/PCM from a “donor” vehicle without having to program it to the test vehicle’s ignition key.

  1. 1.
    Cut a temporary ignition key for the test vehicle with a non-immobiliser key blank.
  2. 2.
    Remove the ECM/PCM from the test vehicle.
  3. 3.
    Write the test vehicle’s VIN on the ECM/PCM you just removed to avoid confusing it with the donor vehicle’s ECM/PCM.
  4. 4.
    Remove the known-good ECM/PCM from the donor vehicle, and install it in the test vehicle.
  5. 5.
    Tape the donor vehicle’s ignition key. The ECM/PCM will recognise the code from the donor vehicle’s key and allow you to start the engine with the temporary key.
Illustration: VEHICLES KEY (DONOR); TEMPORARY KEY
  1. 1. VEHICLES KEY (DONOR)
  2. 2. TEMPORARY KEY
  1. 6.
    After completing your tests, reinstall both ECMs/PCMs and destroy the temporary key.