Workshop manual

Intake Air System

Throttle Body

Supplement 2000 (5-door model) · source: HRV_Workshop_Manual.pdf, PDF pages 1928, 1929 (manual pages 11-149 to 11-150)

PDF p. 1928 · 11-149

Inspection

  1. 1.
    Disconnect the vacuum hose (to the EVAP control canister) from the top of the throttle body; connect a vacuum gauge to the throttle body.
Illustration: VACUUM PUMP/GAUGE
  1. 1. VACUUM PUMP/GAUGE
  1. 2.

    Allow the engine to idle and check that the gauge indicates no vacuum.

    If there is vacuum, check the throttle cable (See Page 11-148).

  2. 3.

    Check that vacuum is indicated on the gauge when the throttle is opened slightly from idle.

    If the gauge indicates no vacuum, check the throttle body port. If the throttle body port is clogged, clean it with carburetor cleaner.

  1. 4.

    Stop the engine and check that the throttle cable operates smoothly without binding or sticking.

    If there are any abnormalities in the above steps, check for:

    • Excessive wear or play in the throttle valve shaft.
    • Sticky or binding throttle link at the fully closed position.
    • Clearance between throttle stop screw and throttle lever at the fully closed position
Illustration: THROTTLE LINK; THROTTLE SCREW STOP, (Do not adjust); There should be no clearance
  1. 1. THROTTLE LINK
  2. 2. THROTTLE SCREW STOP, (Do not adjust)
  3. 3. There should be no clearance

Replace the throttle body if there is excessive play in the throttle valve shaft or if the shaft is binding or sticking.

PDF p. 1929 · 11-150

Removal

Illustration: TP SENSOR; MAP SENSOR; THROTTLE CABLE; GASKET, Replace; 22 Nm (2.2 kgf/m, 16 lbf/ft)
  1. 1. TP SENSOR
  2. 2. MAP SENSOR
  3. 3. THROTTLE CABLE
  4. 4. GASKET, Replace
  5. 5. 22 Nm (2.2 kgf/m, 16 lbf/ft)

NOTE:

  • Do not adjust the throttle stop screw.
  • After reassembly, adjust the throttle cable (See Page 11-148).
  • The TP sensor is not removeable.

Disassembly

Illustration: MAP SENSOR; 2.1 Nm (0.21 kgf/m, 1.5 lbf/ft); O-RING, Replace; O-RING; IDLE ADJUSTING SCREW; CAP; 3.5 Nm (0.35 kgf/m, 2.6 lbf/ft); IAC VALVE; O-RING, Replace; TP SENSOR
  1. 1. MAP SENSOR
  2. 2. 2.1 Nm (0.21 kgf/m, 1.5 lbf/ft)
  3. 3. O-RING, Replace
  4. 4. O-RING
  5. 5. IDLE ADJUSTING SCREW
  6. 6. CAP
  7. 7. 3.5 Nm (0.35 kgf/m, 2.6 lbf/ft)
  8. 8. IAC VALVE
  9. 9. O-RING, Replace
  10. 10. TP SENSOR