PDF p. 1924 · 11-145
Inspection/Adjustment
Adjust the idle speed by means of a Honda PGM-TESTER. If not check the following:
NOTE: Before setting the idle speed, check the following items:
- The MIL has not been reported on.
- Ignition timing
- Spark plugs
- Air cleaner
- PCV system
- 1.Connect a tachometer

- 1. TEST TACHOMETER CONNECTOR
- 2. TACHOMETER
- 3. BATTERY
- 2.Start the engine. Hold the engine at 3,000 rpm (min-1) with no load until the radiator fan comes on, then let it idle.
- 3.
Check the idle speed with no-load conditions:
head-lights, blow fan, rear defogger, radiator fan and air conditioning not operating.
If there is no clicking sound, check the PCV valve grommet for cracks or damage. If the grommet is OK, replace the PCV valve and recheck.
Idle speed should be:
700 + 50 rpm (min-1) (in Park or neutral)
- 4.Adjust the idle speed, if necessary, by turning the idle adjusting screw 1/2 turn clockwise or counterclockwise.

- 1. CAP
- 2. IDLE ADJUSTING SCREW
- 5.
After 1/2 turn the idle adjusting screw, check the idle speed again. If it is out of spec, turn the idle adjusting screw 1/2 turn again.
NOTE: Do not turn the idle adjusting screw more than 1/2 without checking the idle speed.
- 6.
Idle the engine for one minute with heater fan switch at HI and air conditioner on, then check the idle speed.
Idle speed should be:
810 + 50 rpm (min-1) (in Park or neutral)
NOTE:
- Do not turn the idle adjusting screw when the sir conditioner is on.
- If the idle speed is not within specification, see System Troubleshooting Guide.