Workshop manual

Fuel Supply System

Fuel Pressure

Supplement 2000 (5-door model) · source: HRV_Workshop_Manual.pdf, PDF page 1925 (manual page 11-145)

PDF p. 1925 · 11-145

Relieving

Before disconnecting fuel pipes or hoses, release pressure from the system by loosening the fuel pulsation damper on top of the fuel rail.

  1. 1.
    Disconnect the battery negative cable from the battery negative terminal.
  2. 2.
    Remove the fuel fill cap.
  3. 3.
    Use a wrench on the fuel pulsation damper at the fuel rail.
  4. 4.
    Place a rag or shop towel over the fuel pulsation damper.
  5. 5.
    Slowly loosen the fuel pulsation damper one complete turn.
Illustration: FUEL PULSATION DAMPER, 22 Nm (2.2 kgf/m, 16lbf/ft); SHOP TOWEL
  1. 1. FUEL PULSATION DAMPER, 22 Nm (2.2 kgf/m, 16lbf/ft)
  2. 2. SHOP TOWEL

NOTE: Replace the washers whenever the fuel pulsation damper is loosened or removed.

Inspection

  1. 1.
    Relieve the fuel pressure.
  2. 2.
    Remove the fuel pulsation damper from the fuel rail. Attach the fuel pressure gauge attachment and fuel pressure gauge.
Illustration: FUEL PRESSURE GAUGE, 07406-0040002; CLAMP; FUEL PRESSURE REGULATOR; FUEL PRESSURE GAUGE ATTACHMENT, 07VAJ-0090100
  1. 1. FUEL PRESSURE GAUGE, 07406-0040002
  2. 2. CLAMP
  3. 3. FUEL PRESSURE REGULATOR
  4. 4. FUEL PRESSURE GAUGE ATTACHMENT, 07VAJ-0090100
  1. 3.

    Start the engine. Measure the fuel pressure with the engine idling and the vacuum hose of the fuel pressure regulator disconnected from the fuel pressure regulator and pinched. If the engine will not start, turn the ignition switch ON (II), wait for two seconds, turn it off, then back on again and read the fuel pressure.

    Pressure should be:

    260 - 310 kPa (2.7 - 3.2 kgf/cm2, 38 - 46psi)

  2. 4.

    Reconnect the vacuum hose to the fuel pressure regulator.

    Pressure should be:

    200 - 250 kPa (2.0 - 2.5 kgf/cm2, 28 - 36psi)

    If the fuel pressure is not as specified, first check the fuel pump (See Page 11-147). If the fuel pump is OK, check the following:

    • If the fuel pressure is higher than specified, inspect for:
      • Pinched or clogged fuel return hose or line
      • Faulty fuel pressure regulator
    • If the fuel pressure is lower than specified, inspect for:
      • Clogged fuel filter
      • Faulty fuel pressure regulator
      • Leakage in the fuel line.