Workshop manual

Troubleshooting

Troubleshooting Guide

Supplement 2000 (5-door model) · source: HRV_Workshop_Manual.pdf, PDF pages 1913, 1914 (manual pages 11-134 to 11-135)

PDF p. 1913 · 11-134

NOTE: Across each row in the chart, the systems that could be sources of a symptom are ranked in the order they should be inspected starting with (1). Find the symptom in the left column, read across to the most likely source, then refer to the page listed at the top of that column. If inspection shows the system is OK, try the next most likely system (2), etc.

Illustration · Troubleshooting · Troubleshooting Guide

* If codes other than those listed above are indicated, count the number of blinks again. If the MIL is in fact blinking these codes, replace the PCM.

(BU)If the MIL is on while the engine is running, connect the SCS short connector to the service check connector. If no code is displayed (MIL stays on steady), the back-up system is

in operation.

Substitute a known-good PCM and recheck. If the indication goes away, replace the original PCM.

  • *:
    KQ model

PDF p. 1914 · 11-135

Illustration · Troubleshooting · Troubleshooting Guide