Workshop manual

Intake Air System

Fuel Injection Air (FIA) Control Valve Testing

Supplement 2000 (5-door model) · source: HRV_Workshop_Manual.pdf, PDF page 1893 (manual page 11-112)

PDF p. 1893 · 11-112

  1. 1.
    Start the engine.
  2. 2.

    Remove the vacuum hose from the install pipe, and connect a vacuum gauge to the hose.

    NOTE: Engine coolant temperature must be below 65°C (149°F).

Illustration: VACUUM PUMP GAUGE, 0 - 30 in.Hg.
  1. 1. VACUUM PUMP GAUGE, 0 - 30 in.Hg.
  1. 3.

    Raise and lower the engine speed, and make sure the vacuum gauge reading changes as the engine speed changes.

    If the vacuum reading does not change check;

    • the vacuum lines of FIA system for misrouting, leakage, breakage and clogging.
    • the FIA control valve for cracks or damage.
    • check the cooling system (see section 10).
  2. 4.

    Hold the engine at 3,000 rpm (min-1) with no load (A/T in N or P position, M/T in neutral) until the radiator fan comes on, then let it idle and recheck.

    If vacuum reading changes check;

    • the FIA control valve for cracks or damage.
    • check the cooling system (see section 10).