Workshop manual

Idle Control System

Idle Speed Setting

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 403 (manual page 11-73)

PDF p. 403 · 11-73

Inspection/Adjustment

Adjust the idle speed by means of a Honda PGM TESTER. If not, check the following:

NOTE: Before setting the idle speed, check the following items:

  • The MIL has not been reported on.
  • Ignition timing
  • Spark plugs
  • Air cleaner
  • PCV system
  1. 1.
    Connect a tachometer
Illustration: TEST TACHOMETER CONNECTOR; TACHOMETER; BATTERY
  1. 1. TEST TACHOMETER CONNECTOR
  2. 2. TACHOMETER
  3. 3. BATTERY
  1. 2.
    Start the engine. Hold the engine at 3,000 rpm (min-1) with no load until the radiator fan comes on, then let it idle.
  2. 3.

    Check the idle speed with no-load conditions:

    headlights, blow fan, rear defogger, radiator fan and air conditioner not operating.

Idle speed should be:

Except KU model:

M/T750 + 50 rpm (min-1)
A/T700 + 50 rpm (min-1)

(in N or P position)

KU model:

M/T670 + 50 rpm (min-1)
A/T700 + 50 rpm (min-1)

(in N or P position)

  1. 4.
    Adjust the idle speed, if necessary, by turning the idle adjusting screw 1/2-turn clockwise or counter-clockwise.
Illustration: CAP; IDLE ADJUSTING SCREW
  1. 1. CAP
  2. 2. IDLE ADJUSTING SCREW
  1. 5.

    After 1/2-turn the idle adjusting screw, check the idle speed again. If it is out of spec, turn the idle adjusting screw 1/2-turn again.

    NOTE: Do not turn the idle adjusting screw more than 1/2 without checking the idle speed.

  2. 6.

    Idle the engine for one minute with heater fan switch at HI and air conditioner on, then check the idle speed.

    Idle speed should be:

M/T810 + 50 rpm (min-1)
A/T810 + 50 rpm (min-1)

(in N or P position)

NOTE:

  • Do not turn the idle adjusting screw when the air conditioner is on.
  • If the idle speed is not within specification, refer to the System Troubleshooting Guide (See Page 11-61).