PDF p. 392 · 11-62
The idle speed of the engine is controlled by the Idle Air Control (IAC) Valve. The valve changes the amount of air bypassing into the intake manifold in response to electric current controlled by the ECM/PCM. When the IAC Valve is activated, the valve opens to maintain the proper idle speed.

- 1. YEL/BLK
- 2. From PGM-FI MAIN RELAY
- 3. VARIOUS SENSORS
- 4. ECM/PCM
- 5. BLK/BLU
- 6. ORN
- 7. BLK
- 8. INTAKE MANIFOLD
- 9. ENGINE COOLANT
- 10. IAC VALVE
- 1.After the engine starts, the IAC valve opens for a certain time. The amount of air is increased to raise the idle speed about 150-300 rpm (min-1)
- 2.When the coolant temperature is low, the IAC valve is opened to obtain the proper fast idle speed. The amount of bypassed air is thus controlled in relation to the engine coolant temperature.
- 3.When the idle speed is out of specification and the Malfunction Indicator Lamp (MIL) does not indicate Diagnostic Trouble Code (DTC) 14, check the following items:
- Air conditioning signal (See Page 11-65)
- ALT FR signal (See Page 11-67)
- Brake switch signal (See Page 11-69)
- Starter switch signal (See Page 11-70)
- PSP switch signal (See Page 11-71)
- A/T gear position signal (see section 14)
- Hoses and connections
- IAC valve and it’s mounting O-rings
- 4.If the above items are normal (and the MIL does not indicate DTC 14), after IAC valve replacement, substitute a know-good ECM/PCM and recheck. If symptom goes away, replace the original ECM/PCM.