Workshop manual

Idle Control System

System Troubleshooting Guide

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 391 (manual page 11-61)

PDF p. 391 · 11-61

NOTE:

  • Across each row in the chart, the sub-systems that could be sources of a symptom are ranked in the order they should be inspected, starting with 1. Find the symptom in the left column, read across to the most likely source, then refer to the page listed at the top of that column. If inspections shows the system is OK, try the next system 2. etc.
  • If the idle speed is out of specification and the Malfunction Indicator Lamp (MIL) does not blink Diagnostic Trouble Code (DTC) 14, go to inspection (See Page 11-62).
SUB-SYSTEMIDLE AIRAIRALTERNATORBRAKESTARTERPOWERAUTOMATICHOSES AND
CONTROLCONDITIONINGFR SIGNALSWITCHSWITCHSTEERINGTRANSAXLEC0NNECTIONS
VALVESIGNALSIGNALSIGNALPRESSUREGEAR
SWITCHPOSITION
SIGNALSIGNAL *1
PAGE11-6311-6511-6711-6911-7011-71Section 14-
SYMPTOM
DIFFICULT TO START ENGINE WHEN1
COLD
WHEN COLD FAST IDLE OUT OF1
SPEC.[1,000-2,000 rpm (min-1)]
ROUGH IDLE21
WHEN WARM ENGINE SPEED TOO HIGH132
WHEN WARMIdle speed is below1
RPM TOO LOWspecified rpm (no load
WHEN WARMIdle speed does not1
RPM TOO LOWincrease after initial
start up
WHEN WARMOn models with21
RPM TOO LOWautomatic transmission,
the idle speed drops in
gear.
WHEN WARMIdle speeds drops when21
RPM TOO LOWair conditioning is ON.
WHEN WARMIdle speed drops when21
RPM TOO LOWsteering wheel is turning
WHEN WARMIdle speed fluctuates231
RPM TOO LOWwith electrical load
FREQUENTWHILE WARMING UP1
STALLING
FREQUENTAFTER WARMING UP1
STALLING
FAILS EMISSION TEST1
  • *1
    : A/T