PDF p. 434 · 11-104
The emission control system includes a Three Way Catalytic Converter (TWC), Positive Crankcase Ventilation (PCV) system and Evaporative Emission (EVAP) Control system.
Tailpipe Emission
Inspection
- 1.Connect a tachometer.
- 2.Start the engine. Hold the engine at 3,000 rpm (min-1) with no load (in Park or neutral) until the radiator fan comes on, then let it idle.
- 3.Check the idle speed (See Page 11-73).
- 4.Warm up and calibrate the CO meter according to the meter manufacturer’s instructions.
- 5.
Check idle CO with headlights, heater blower, rear window defogger, cooling fan, and air conditioner off.
Specified CO%:
For cars with TWC model: 0.1% maximum
For cars without TWC model: 1.0 ± 1.0%
- If unable to obtain this reading:
- Without TWC model, adjust by turning the adjusting screw of the IMA.
- With TWC model, see ECM/PCM troubleshooting guide (See Page 11-27).

- 1. ADJUSTING SCREW
- 2. CAP
- 3. IMA
- If unable to obtain a CO reading of specified % by this procedure, check the engine tune-up condition.
Three Way Catalytic Converter (TWC)
Description
The Three Way Catalytic Converter (TWC) is used to convert hydrocarbons (HC), carbon monoxide (CO) and oxides of nitrogen (Nox) in the exhaust gas, to carbon dioxide (CO2), dinitrogen (N2) and water vapour.

- 1. HOUSING
- 2. THREE WAY CATALYSTS
- 3. FRONT OF VEHICLE
Removal/Installation (see section 9)
Inspection
If excessive exhaust system back pressure is suspected, remove the TWC from the car and using a flashlight, make a visual check for plugging, melting or cracking of the catalyst. Replace the TWC if any of the visible area is damaged or plugged.

- 1. FLASHLIGHT
- 2. TWC