Workshop manual

Intake Air System

Throttle Cable

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 430 (manual page 11-100)

PDF p. 430 · 11-100

Inspection/Adjustment

  1. 1.
    Start the engine. Hold the engine at 3,000 rpm (min-1) with no load (in Park or neutral) until the radiator fan comes on, then let it idle.
  2. 2.
    Check that the throttle cable operates smoothly with no binding or sticking. Repair as necessary.
  3. 3.
    Check cable free play at the throttle link. Cable deflection should be 10-12 mm (3/8-1/2 in).
Illustration: LOCKNUT; ADJUSTING NUT; DEFLECTION 10-12 mm (3/8-1/2 in); CABLE BRACKET
  1. 1. LOCKNUT
  2. 2. ADJUSTING NUT
  3. 3. DEFLECTION 10-12 mm (3/8-1/2 in)
  4. 4. CABLE BRACKET
  1. 4.
    If deflection is not within specs, loosen the locknut, turn the adjusting nut until the deflection is as specified, then retighten the locknut.
  2. 5.
    With the cable properly adjusted, check the throttle valve to be sure it opens fully when you push the accelerator pedal to the floor, Also check the throttle valve to be sure it returns to the idle position when ever you release the accelerator pedal.

Installation

  1. 1.
    Open the throttle valve fully, then install the throttle cable in the throttle link and install the cable housing in the cable bracket.
Illustration: LOCKNUT; ADJUSTING NUT; INNER CABLE; THROTTLE LINK; CABLE BRACKET
  1. 1. LOCKNUT
  2. 2. ADJUSTING NUT
  3. 3. INNER CABLE
  4. 4. THROTTLE LINK
  5. 5. CABLE BRACKET
  1. 2.
    Start the engine. Hold the engine at 3,000 rpm (min-1) with no load (In Park or neutral) until the radiator fan comes on, then let it idle.
  2. 3.
    Hold the cable sheath, removing all slack from the cable.
  3. 4.

    Set the locknut on the cable bracket.

    Adjust the adjusting nut so that its free play is 0

    mm (0 in).

  4. 5.
    Remove the cable sheath from the throttle bracket, rest the adjusting nut and tighten the locknut.
Illustration: LOCKNUT; CABLE BRACKET; ADJUSTING NUT; There should be no clearance; 9.8 Nm (1.0 kgf/m, 7.2 lbf/ft); CABLE SHEATH
  1. 1. LOCKNUT
  2. 2. CABLE BRACKET
  3. 3. ADJUSTING NUT
  4. 4. There should be no clearance
  5. 5. 9.8 Nm (1.0 kgf/m, 7.2 lbf/ft)
  6. 6. CABLE SHEATH