PDF p. 1771 · 6-9
Manual Inspection
- 1.Set the No. 1 piston at TDC.
- 2.Remove the cylinder head cover.
- 3.Push the intake mid rocker arm on the No. 1 cylinder manually.
- 4.Check that the intake mid rocker arm moves independently of the primary and secondary intake rocker arms.

- 1. MID ROCKER ARM
- 2. SECONDARY ROCKER ARM
- 3. PRIMARY ROCKER ARM
- 5.Check the intake mid rocker arm of each cylinder at TDC.
- If the intake mid rocker arm does not move, remove the mid, primary and secondary intake rocker arms as an assembly and check that the pistons in the mid and primary rocker arms move smoothly.
- If any rocker arm needs replacing, replace the primary, mid and secondary rocker arms as an assembly
Inspection Using Special Tools
NOTE:
- Before using the Valve Inspection Tool, make sure that the air pressure gauge on the air compressor indicates over 400 kPa (4 kgf/cm2, 57 psi).
- Inspect the valve clearance before rocker arm inspection.
- Cover the timing belt with a shop towel to protect the belt.
- Check the intake primary rocker arm of each cylinder at TDC.
- 1.Remove the cylinder head cover.
- 2.Plug the relief hole with the special tool.

- 1. RELIEF HOLE
- 2. AIR STOPPER, 07LAJ - PR30201
PDF p. 1772 · 6-10
- 3.
Remove the sealing bolt from the inspection hole, and connect the special tool.
NOTE: Remove any oil from the bolt threads and camshaft holder threads before retightening the sealing bolt.

- 1. 10 x 1.0 mm SEALING BOLT, 20 Nm (2.0 kgf/m, 14 lbf/ft)
- 2. AIR STOPPER, 07LAJ - PR30201
- 3. VALVE INSPECTION SET, 07LAJ - PR30101
♦ Pull the dial and turn to adjust. - 4. INSPECTION HOLE
- 4.
Loosen the regulator valve on the valve inspection tool, and apply the specified air pressure to the rocker arm synchronising pistons A/B.
Specified Air Pressure:
250kPa (2.5 kgf/cm2, 36 psi)
- 5.Make sure that the intake primary and secondary rocker arms are mechanically connected by piston and that the mid rocker arm does not move when pushed manually.

- 1. MID ROCKER ARM
- 2. SECONDARY ROCKER ARM
- 3. PRIMARY ROCKER ARM
- If the intake mid rocker arms move independently of the primary and secondary rocker arms, replace the rocker arms as a set.
PDF p. 1773 · 6-11
- 6.Remove the special tools.
- 7.Use a 10 mm diameter rod to depress each lost motion assembly through its full movement. Replace any lost motion assembly that does not move smoothly.

- 1. LOST MOTION ASSEMBLY
- 8.After inspection, check that the MIL does not come on.