Workshop manual

Connecting Rod and Crankshaft

End Play

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 277 (manual page 7-7)

PDF p. 277 · 7-7

Connecting Rod End Play:

Standard (New):0.15 - 0.30 mm
(0.006 - 0.012 in)
Service Limits:0.40 mm (0.016 in)
Illustration · Connecting Rod End Play
  • If out-of-tolerance, install a new connecting rod.
  • If still out-of-tolerance, replace the crankshaft (See Page 7-11) and (See Page 7-22).

Push the crankshaft firmly away from the dial indicator and zero the dial against the end of the crankshaft. Then pull the crankshaft firmly back towards the indicator; dial reading should not exceed service limit.

Illustration · Connecting Rod End Play

Crankshaft End Play:

Standard (New):0.10 - 0.35 mm
(0.004 - 0.014 in)
Service Limit:0.45 mm (0.018 in)
  • If end play is excessive, inspect the thrust washers and thrust surface on the crankshaft. Replace parts as necessary.

NOTE: Thrust washer thickness is fixed and must not be changed either by grinding or shimming.

Thrust washers are installed with grooved sides facing outwards.