Workshop manual

Timing Belt

Inspection

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 246 (manual page 6-7)

PDF p. 246 · 6-7

  1. 1.
    Remove the breather hose, then remove the air cleaner housing (see page 5-4).
  2. 2.
    Remove the cylinder head cover.
    • When installing (see page 6-30).
  3. 3.
    Remove the upper cover (see page 6-9).
  4. 4.

    Inspect the timing belt for cracks and oil or coolant soaking.

    NOTE:

    • Replace the belt if oil or coolant soaked.
    • Remove any oil or solvent that gets on the belt.
Illustration: Inspect this area for wear.; Rotate pulley and inspect belt.
  1. 1. Inspect this area for wear.
  2. 2. Rotate pulley and inspect belt.
  1. 5.
    After inspecting, loosen the crankshaft pulley bolt, then retorque the crankshaft pulley bolt to 20 Nm (2.0 kgf/m, 14 lbf/ft) + 90°.

Tension Adjustment

NOTE:

  • Always adjust the timing belt tension with the engine cold.
  • The tensioner is spring-loaded to apply tension to the belt automatically after making the following adjustment.
  • Always rotate the crankshaft counterclockwise when viewed from the pulley side. Rotating it clockwise may result in improper adjustment of the belt tension.
  • Inspect the timing belt before adjusting the belt tension.
  1. 1.
    Remove the breather hose, then remove the air cleaner housing (see page 5-4).
  2. 2.
    Remove the cylinder head cover.
    • When installing (see page 6-30).
  3. 3.
    Remove the upper cover (see page 6-9).
  4. 4.
    Rotate the crankshaft five or six revolutions to set the belt.
  5. 5.
    Set the No.1 piston at TDC (see page 6-11).
  6. 6.
    Loosen the adjusting bolt 180°.
Illustration: ADJUSTING BOLT, 44 Nm (4.5 kgf/m, 33 lbf/ft).; Direction of rotation.
  1. 1. ADJUSTING BOLT, 44 Nm (4.5 kgf/m, 33 lbf/ft).
  2. 2. Direction of rotation.
  1. 7.
    Rotate the crankshaft counterclockwise three teeth on the camshaft pulley.
  2. 8.
    Tighten the adjusting bolt.
  3. 9.
    After inspecting, loosen the crankshaft pulley bolt, then retorque the crankshaft pulley bolt to 20 Nm (2.0 kgf/m, 14 lbf/ft) + 90°.