PDF p. 144 · 1-11
- Protect all painted surfaces and seats against dirt and scratches with a clean cloth or vinyl cover.

- Work safely and give your work your undivided attention. When either the front or rear wheels are to be raised, block the remaining wheels securely. Communicate as frequently as possible when work involves two or more workers. Do not run the engine unless the shop or working area is well ventilated.

- Before removing or disassembling parts, they must be inspected carefully to isolate the cause for which service is necessary. Observe all safety notes and precautions and follow the proper procedures as described in this manual.

- Mark or place all removed parts in order in a parts rack so they can be reassembled in their original places.

- Use the special tool when use of such a tool is specified.

- Parts must be assembled with the proper torque according to the maintenance standards established.
- When tightening a series of bolts or nuts, begin with the centre or large diameter bolts and tighten them in criss-cross pattern in two or more steps.

PDF p. 145 · 1-12
- Use new packing, gaskets, O-rings and cotter pins whenever reassembling.
- Do not reuse parts that are required to be replaced. Always replace them.

- Use genuine HONDA parts and lubricants or those equivalent. When parts are to be reused, they must be inspected carefully to make sure they are not damaged or deteriorated and are in good usable condition.

- Coat or fill parts with specified grease as specified (page 3-2). Clean all removed parts with solvent upon disassembly.

- Brake fluid and hydraulic components
- When replenishing the system, use extreme care to prevent dust and dirt from entering the system.
- Do not mix different brands of fluid as they may not be compatible
- Do not reuse drained brake fluid.
- Because brake fluid can cause damage to painted and resin surfaces, care should be taken not to spill it on such surfaces. If spilled accidentally, quickly rinse it off with water or warm water from all painted or resin surfaces.
- After disconnecting brake hoses or pipes, be sure to plug the openings to prevent loss of brake fluid.
- Clean all disassembled parts only in clean BRAKE FLUID. Blow open all holes and passages with compressed air.

- Keep disassembled parts away from air-borne dust and abrasives.
- Check that parts are clean before assembly.
- Avoid oil or grease getting on rubber parts and tubes, unless specified.
- Upon assembling, check every part for proper installation and operation.
