Workshop manual

Seat Heaters

Heater Test

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 1258 (manual page 23-F-38)

PDF p. 1258 · 23-F-38

  1. 1.
    Remove the front seat (see section 20), then disconnect the 6P and 2P connectors as shown below.
  2. 2.

    Check for continuity between the No. 1 and No. 5 terminals of the 6P connector and between the No. 1 and No. 2 terminals of the 2P connector (R x 10 3 scale).

    There should be continuity.

Illustration: Wire side of female terminals; 2P CONNECTOR; 6P CONNECTOR; Wire side of female terminals; SEAT HEATER RELAY; 2P CONNECTOR (To main wire harness)
  1. 1. Wire side of female terminals
  2. 2. 2P CONNECTOR
  3. 3. 6P CONNECTOR
  4. 4. Wire side of female terminals
  5. 5. SEAT HEATER RELAY
  6. 6. 2P CONNECTOR (To main wire harness)

Relay Test

  1. 1.
    Remove the front seat (section 20) then remove the seat heater relay from the bottom of the seat.
  2. 2.

    There should be continuity between the No. 1 and No. 6 terminals and between the No. 3 and No. 4 terminals when power and ground are connected across the No. 5 and No. 6 terminals.

    There should be continuity between the No. 4 and No. 6 terminals when power is disconnected.

Illustration · Relay Test